Toilet Parts - Diagnosing the Problem

When your toilet is broken it's always a rush to get itbottom of the tank. One pipe will have a valve on
fixed. A lot of times you can fix it your self with outthe top with the float attached to it. The other pipe
the need for an expensive plumber. A toilet has verywill be open on the top. This is the over flow pipe.
few parts to wear out or break and most of thoseSee how far up the water level is on the over flow
parts are not very expensive. So basically it justpipe, if it goes all of the way to the top then your
takes a little time, and some know-how, to set thingsfloat is set too high. Just bend the float arm down so
right.that the water shuts off before the level reaches
What we are going to do here is to list some of thethe top of the pipe.
more common toilet parts and how to fix theIf the water is running and does not reach the top
problems that they cause. If the fix for the problemof the over flow pipe then it is probably a problem
is going to require you to take any parts loose thenwith the flapper valve. On the back of the flush
be sure and turn off the water supply to the toilethandle there as an arm with a small chain on the end
first.which leads to the flapper valve. If this chain is too
The first problem that we will discuss is a runningtight or kinked it may be holding the valve open
toilet where you can hear the water running eitherenough to allow it to leak. If not you may have to
continuously or it will seem to start and stop on itsreplace the flapper valve.
own. This can be very annoying not to mentionThese are only a couple of the problems that may
costly with water bills going up all the time. First takehappen with a toilet. Most problems can be diagnosed
the lid off of the toilet tank and have a look inside.with a little observation and some common sense,
There should be two pipes coming up from theand the changing out of a few toilet parts.