Do-It-Yourself Toilet Installation

Toilet installation is a pretty common do-it-yourselfinstallation project.
project. If you carry out each step of the processAligning Parts Properly - This may seem like a basic
carefully, it does not have to be difficult. There are,consideration for a do-it-yourself project, but proper
however, some potential problems you could run into.alignment often gets overlooked. For instance, using
Follow the suggestions below to avoid those issuespipes that are nearly the same size will not cut it.
that could easily derail your project.This is because they will align improperly and cause
Local Codes - Many people forget that there areplumbing problems. Always check that your pipes and
plumbing codes that need to be followed during atubes fit exactly and that nuts have not been forced
home toilet installation. Before you begin youron at an incorrect angle.
project, do some research into what the codes areRemove Dirt and Air from Pipes - After you finish
in your area. Ask a friend who has done it before oryour installation, you will surely be eager to clean up
you can ask a knowledgeable employee at aand be done. You cannot, however, skip the
hardware store, or even a local plumber whom youimportant step of bleeding the lines of dirt, air, and
trust.other debris. Do this by flushing the toilet or running
Keep Everything Level - Your toilet installation maythe outside hose valve.
seem like it has gone fine, but you can run into aDo-it-yourself toilet installation is a project you can
mess later on if you do not check that your toilet'scomplete successfully. Be sure to avoid the common
level. You need to do this through every step ofmistakes that many people make during the
your project. Keep your level handy, and do notinstallation process. Taking care to do so will save
neglect to check it regularly during the toiletyou time and hassle later on.